Posted by admin | Posted in Parts And Stuff | Posted on 23-12-2009
Tags: power, regulator, surge, tv, voltage
Meter Voltage Line
 |
 RV 110 VOLT METER VOLTAGE LINE TESTER  US $14.70
|
 CCD COLOR INFRARED WIDE ANGLE REAR VIEW BACKUP CAMERA US $99.99
|
 HBA1600 PSI HYDRASTAR TEKONSHA BREAKAWAYPRODIGY P2 US $945.00
|
 HBA1200 PSI HYDRASTAR TEKONSHA BREAKAWAYPRODIGY P2 US $905.00
|
 110 VOLT LINE VOLTAGE METER RV HOMEBOAT US $18.95
|
 HBA1000 PSI HYDRASTAR TEKONSHA BREAKAWAYPRODIGY P2 US $885.00
|
 Power Inverter Battery Charger Combination marine RV US $1,099.00
|
 7 COLOR LCD MONITOR CCD REAR VIEW BACKUP CAMERA SYSTEM US $179.99
|
 TRC Electra Check Digital Power Monitor RV line diagnostic generator invertor US $59.99
|
 REAR VIEW BACKUP CAMERA HQ CCD NIGHT VISION WIDE ANGLE US $104.99
|
 Bogart Engineering 1000Amp 100mV Shunt SWB 1000 100 US $71.00
|
 Magnum Energy MS4024 4000 watt 24 volt Inverter Charger FREE ME RC50 ME BMK US $2,079.20
|
 Digital AC Line Voltage Meter and Polarity Tester for 120 Volt Outlet US $29.95
|
 RV AC Line Voltage Meter for 120 Volt Outlet US $15.95
|
 RV Motorhome AC Voltage Polarity Digital Tester Trailer Camper AC Line Meter US $49.99
|
 AC Line Voltage Meter US $15.95
|
 PORTABLE GENERATOR RV AC LINE VOLTAGE METER US $13.99
|
 CCD SIDE VIEW CAMERAS COLOR REVERSE NORMAL NIGHT VISION US $119.99
|
 CAMCO 55263 120 VOLT RV AIR CONDITIONER VOLTAGE METER US $24.99
|
 7 COLOR REAR VIEW BACKUP CAMERA SYSTEM TFT LCDCCD Cam US $256.99
|
A/C supply fan question?
I have a 230V single phase two speed motor that I am trying to check. There are four wires on it. One red, one orange, and two black. The wiring diagram shows the red as Lo and one of the blacks as Hi. The orange is shown as hooking to line voltage and another wire that is not marked on the diagram (I assume the other black). Is there any way to tell with a meter what goes where so that I can bench test it?
yes, the internal wiring of a motor isnt standard, it's whatever the factory wants to use.- at least color-wise. normally they use labels with numbers or numbers with a 'T' before them
you can try the following
hook the orange wire to one power wire and the last one whatever it was to the other power wire - this is the starter circut.
from the point where you hooked up the orange wire hook up either the 'hi' wire or 'lo' wire depending on what speed you want ( you could also wire a 3-way switch to toggle between the hi or lo speed. hook the black or odd colored screw on the switch to the same point where the oraqnge wire connects, the other 2 screws receive the 'hi' and 'lo' wires. this way you can flip the switch between the two speeds)
